Sending attack error, cannot confirm send army.

[betonron]

Hello there,

I have been using UTWB on a VPS, however I keep getting the following error:

Can not confirm send army. Error message:
***** X:Y(xxx:yyy) → *dorp X:Y(xxx:yyy) Description:

How can I solve this problem?

[ttim]

Did you set the origin village?

[mpcdeus]

I got same message here

some attacks go correctly, some show error message "cannot confirm send army"

running on Windows 7

[mike123]

I sometimes get the same thing. The troops did get sent when I check.
Running Windows 10

[mpcdeus]

I found a partial solution for this problem:

Apparently the cause is high cpu usage, so, I reduce the active modules, stoping recruit, building, ifarm, reports reading, log and ressource balance.

Just leaving active sending troops and time sync

Now it's working well again.

[fantasma]

i have issue all over now... 6 villages, 3..5..10 LC per send.... 2sec..5sec...10sec delay between sends.. dont matter
and ive tried ONLY using Send Army NOTHING ELSE! Im lucky if i end up with 2 villages that work sometimes

and CPU usage is nearly sleeping ... so Bot still buggy still..

on I7-5820K, 16 Gb Ram...

[hex4bot]

Probably it was related to executing scripts in CEF(internal chrome used in bot). I was able to reproduce this problem once on my machine - and got the log with the problem, so I fixed it and now all should be fine. If not then I will investigate further.

[mijadoria]

sending multiple attacks simulating fake NT with 4 rams in 100 ms bot shuting down!

With this new version the problem persists!

Repair this please.